Chaincutter HC 530-3-W

Chaincutter HC 530-3-W by PETIG
Chaincutter HC 530-3-W by PETIG (similar picture).
Knive-type: W
Performance: up to Ø 30 mm with a hardness of 700 N/mm²
up to Ø 25 mm with a hardness of 1400 N/mm² 
Working pressure: 550 bar
Equipment:

Provided with splinter protection
Limit switch with safety interlock
Mounted on a plate

For safety reasons, the product is mounted on a rack / trolley or plate and operated with a foot switch.

General

The high performance steel cutters of the CHAINCUTTER series are based on the HYDROCUT technology of PETIG. They cut chains up to a chain link diameter of 50 mm. To power the cutter there are stationary high-pressure hydraulic pump units as well as portable hydraulic pumps available. The cutting force goes from 170 - 1100 kN.

CHAINCUTTERs are equipped with “W”-type blades (see HYDROCUTS chapter).

Chain cutters are mounted on a plate and have a protective case to ensure the worker’s safety.

Recommended hydraulic pumps for this device:

KA 22

  • with 1,1 kW 3-phase motor
  • Capacity: 2,52 l/min. at 400 V/ 50 Hz, 550 bar
  • theor. cutting time: 6,8 s

KA 44

  • with 3,2 kW 3-phase motor
  • Capacity: 4,67 l/min. at 400 V/ 50 Hz, 550 bar
  • theor. cutting time: 3,6 s

RKP 7

  • with 7,5 kW 3-phase motor
  • Capacity: 7,4 l/min. at 400 V/ 50 Hz, 550 bar
  • theor. cutting time: 2,3 s

RKP 11

  • with 11 kW 3-phase-motor
  • Capacity: 11 l/min. at 400 V/ 50 Hz, 550 bar
  • theor. cutting time: 1,5 s

RKP 15

  • with 15 kW 3-phase-motor
  • Capacity: 15 l/min. at 400 V/ 50 Hz, 550 bar
  • theor. cutting time: 1,2 s

Changes and errors excepted.

You have questions about our products?
Then contact us, we look forward to your inquiry!